Farm Equipment Livestock Waterers For Sale In Memphis

The 303 Riser Tube protects the water supply line from the cold by insulating it in urethane foam, and warming it with a low wattage heating element. Water and electric lines run underground below frost line.

Screw that holds the float connect to the top of the float.

Robert's Brass 1/2" plunger only for replacement in existing 1/2" valve.

This Shut off ball valve is to be used on Models 101, 202 & 404 with or without heat.

1 per model EXCEPT 404 models need 2 kits. Weather seal Kit for Jug 101, 202 & 404 with or without heat.

White styrofoam triangular disc float only.

Heating element ONLY for all Johnson Concrete Models EXCEPT the J360.

Horseshoe shaped 285 Watt element used in all Franklin galvanized waterers.

Robert's 3/4" leather cup ring that fits on the brass plunger.

Heating element ONLY for the Johnson Concrete Model J360.

It moves the upper arm and is also held by thumbscrew to the float arm. The lower arm is blue and is located in the bottom bracket of the top base and is held by a lock pin.

This repair kit will fit in all Apex Valves & is made for use in all high pressure or low pressure applications.

Johnson Waterer Element Clips to hold the heating element.

Unique baffles guard against icing & keep valve operating under severest conditions. Nature's ground water temperature does this job. Seamless sidewall cannot leak. Livestock can drink out of both flaps at the same time, not always so with a ball closure.

Drinker wells are 14" deep allowing most any animal to drink naturally. Two large drink openings 8" x 14" each. You don't need extra heat to keep the line above the ground open. Tough enough for years of outdoor use.

A drain plug for Arkfeld waterers - 1 1/2" in size - Cork.

It is a split plastic coupler that fits into the corrugation of the Earth Tube. Used for joining multiple Earth Tubes.

1000 Watt Immersible element used in the PC2 or PC10 waterer.

20 Gallon, 36" x 35" x 25" - 1060# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

The Tru-Test Apex Xtraflo 3/4" or 1" Trough Valve is a full flow - diaphragm activated, armless, self-cleaning valve mechanism. It has an above water float adjustment, cord cleat for shutting off valve and a 1 1/2" water level differential from open to...

This drain plug fits Models 101, 202, 303 & 404 with or without heat.

This unit has the same description as the J303 EXCEPT THIS UNIT HAS NO HEAT!

White polyethylene disc float only.

600 watt x 120 volt heating element with surface mount thermostat included. Arkfeld waterer element & thermostat replacement.