Used Equipment Water Equipment For Sale In St George

1000 GALLON WATER TRUCK WITH HOMELITE PUMP, CAMELBACK

With a 2000 gallon water tank. Very nice looking Mack water truck. Motor seems to run really well.

WITH NEW HYDROFORCE 4000 GALLON TANK AND WATER SYSTEM, REAR DUST HEADS, STREET FLUSHING SHOE, OVER THE TOP FILL WITH AIR GAP, 2 SIGHT TUBES, OUTSIDE LADDERS, 8' DRIP BAR, HOSE AND CAB CONTROLS

SINGLE AXLE WATER TRUCK WITH 2000 GALLON TANK, 8HP BRIGGS AND STRATTON ENGINE

Ford tractor with practically new tires, has been converted from 6 volt to 12, new carbarator, electonic start, 4 speed. Will sacrifice all for $4500.00 Runs great! Comes with 5 foot bush hog, never been used spreader, never been used 6 foot box blade...

THIS UNIT IS BEING SOLD WITH A POWERSCREEN RADIAL STACKER. BOTH UNITS CAN BE PURCHASED SEPERATE BUT ARE BEING OFFERED TOGETHER. LISTER-PETTER DIESEL WITH RELATIVELY LOW HOURS.

ROPS CANOPY,GOOD RUNNER, CHAINS AND SPROCKETS 85%, FLIGHTS HAVE BEEN BUILT UP Hours need to be verified

Pump will need to be rebuilt and sealed eventually. Comes with: 20' of 8" Hose 70' of 6" Hose 150-200' of Discharge Hose Butterfly Valves and Bauer Fittings Trailer Mounted 8" Pump, Deere 4045 Engine Pump is operating at 50-60% efficiency.

15" Wide Bucket.

24" Bucket, Good Condition 15" Length of PinCenter to Center Sitting in St. George, SC yard

Stump Puller/Shear/Splitter

See dimensions below. Could fit other units outside of Volvo. HYDRAULIC Thumb, Good Condition.

CAT BROOM FOR SKID-STEER, 1-OWNER, READY TO WORK

Drive Axle for Volvo L150C Loader.

3 Pin Holes 1" pin Holes 18" Wide 271/2" Length

23" wide 38 1/2 length Front Holes 21/4 pin size Rear Holes 2" pin size 13 1/2" Outside mounting pin Bracket 10" Inside mounting pin Bracket

A30D Beds with Cylinders 3 AVAILABLE

BUCKET FOR CAT 330 SIZE MACHINE, TEETH AND SIDE-CUTTERS, GOOD SHAPE

Good Condition. Two 4' compactorsex DOT.

Forestry Grapple.

24" wide bucket 18" Deep bucket 1' Pins 71/2" center of pins 41/2" Inside width pin mount 8" overall width pin mount 5-Teeth

35" HEAVY DUTY BUCKET FOR A CAT 320, GREAT SHAPE, USED VERY LITTLE

COMPLETE TOPCON AUTOGRADE FOR ASPHALT PAVING, GREAT CONDITION, READY TO GO

BOBCAT SKID STEER AUGER THAT FITS MOST SKID STEERS, IN GOOD SHAPE AND COMES WITH 1 BIT

Good Condition 18" Pin LengthCenter to Center Sitting in St. George, SC 60" Clean out bucket.