Used Equipment Sweepers Broom Equipment For Sale In Brookshire

Balderson Blade with Quick Connect for Wheel Loader 988 In good condition was used with a 988F wheel loader.

Fits Caterpillar 140H, 143H, 160H, 163H, 104G

Butterfly valves and flange valves are brand new. Can ship anywhere or pick you up at the airport. This trailer has been sand blasted and has fresh paint, the liner on the inside is brand new, just lined.

Works good, good rails. Spring suspension. 1999 Galbreath Model: A5-OR-402 Roll Off Trailer, Tri-axle with big tires, 30,000lbs G.VW.R, 21,200lbs G.A.W.R., cable hoist roll off, 5th wheel.

6 x 14.00 x 24 Tires Only @ 50% Remaining.

Both Blade and bucket for 988B

Complete With Mounting Rods. Original Cat Multi Shank Ripper Came Of A 140H Has 3 Cat Ripper And 8 Cat Scarifier Shanks, In Excellent Conditoin .

Truck sells DOT inspected, ready to work. DOT relief valve. Fresh paint all around, good tires. Stainless steel NVE air activated and manual safety valves in the rear, DOT approved.

Sells DOT inspected. This truck has been serviced at the Peterbilt dealer as well. PTO is activated outside of cab on drivers side, with clutch lever and pto lever so you dont have to hop in the truck to activate pto.

2006 Mack CHN613 Vacuum Truck with 413,000 miles. Truck sells DOT inspected, ready to work. Mack 427HP engine, eaton fuller 13 speed, NVE vacuum pump with transfer gear pump too, tandem axle, air ride, 3,500 gallon vacuum tank, 3.90 ratio, 230"in wheelbase,...

Truck is powered by the very reliable and legendary Mack E7 engine. Spring suspension, heavy spec, double frame. Double frame, Maxitorque 13 speed. 2001 Mack RD688S Bobtail Kill Truck/ pressure truck/ pump truck with 60BBL Vacuum tank, with 260,000 miles,...

A/C Condition: Excellent, A/C, Differential Lock, State DOT, Lift Axle, Lift Axle Type: Mid 2008 International 7600 Vactor HXX Hydroexcavator with a big blower, Hibon 8702, 29"HG, 5600 cfm, Caterpillar C13, Eaton Fuller 10 speed, full open rear gate,...

OVERALL LENGTH : 59'-8" MAIN DECK LENGTH : 45' UPPER DECK LENGTH : 14'-6" WIDTH : 102" SWING CLEARANCE : 102" - 120" KING PIN SETTING : 16" - 34" DECK HEIGHT : 40" - 41" 2008 Traileze 4 axle Lowboy/ RGN/ oil field trailer, 25,000lbs each axle with air...

G&H 60,000lbs roll off cable hoist. No cylinder leaks, no hydraulic leaks or any oil leaks for that matter. Hydraulic tarp with brand new tarp on it. 2004 Mack CH613 Roll Off with 297,000 miles.

Truck sells DOT inspected, ready to work. Hendrickson Walking beam suspension, 20,000lbs fronts and 58,000lbs rears. Eaton Fuller 8 speed with lo, lo, lo. Beautiful monster 2006 Mack Granite CV713 Gin Pole Winch Truck with 123,000 miles!!! Mack AMI 12.0L...

Blower hours are 3,002 hours. All gauges in control panel working and inside cab, no check lights, or leaks. Cab and chassis. Heavy specs, double frame, 20,000lbs fronts and 46,000lbs rears.

Ready to work, DOT inspected. These trucks are working good, and have no problems. One has 60k miles and the other has 102k miles, Cummins ISX 475HP, Eaton Fuller 18 speed, Gardener Denver TEEAC 5,000psi pump, MCM 3X4 pump, NVE Challenger 367 vacuum pump,...

Blower hours are 3,002 hours. The dash on interior is very good, no broken pieces on dash or cracks. Roots Trinado LR05-4507 blower, 29” HG and 5,600cfm. Caterpillar C-13, 25,000 miles, eaton fuller 10 speed, Engine hours are 5,102 hours.

All fully working. Cummins ISX 425HP or Paccar engine, 3,600 total engine hours and 1,800 blower hours. 2012 and 2013 Kenworths T800 Ramvac HX-12 Hydrovac with low miles from 20,000 to 80,000 miles.

With 14,000 original miles (computer verified) and 8,000 hours. This truck has been fully refurbished and is ready to work. Keith Huber DOT code/ Hazmat 3,030gal 407/412. 2005 Sterling Vacuum Truck DOT CODE/HAZMAT/ 407/412.

COMES EQUIPPED WITH 5 SHANKS IN STOCK READY FOR DELIVERY. MADE IN USA NEW / UNUSED SCARIFIER NEW UN TO FIT 140M, 12M, 160M .

Good Tires All Around, Has A Blower

Real clean truck, no check lights, air leaks or oil leaks. It has full rolling tailboard, hydraulic Tulsa 45,000lbs winch and a hydraulic NVE 367 Challenger vacuum pump, 14,000lbs fronts and 40,000lbs rears.

A/C Condition: Excellent, A/C, Differential Lock, State DOT, Turbo 2007 Mack CH613 Winch Truck with a vacuum pump, ready to work. Air ride, 16,000lbs fronts and 40,000lbs rears. Fresh oil changed, greased and lubed, no air leaks or check lights, Works...