Used Equipment Forage For Sale In Vermont

Self propelled chopper, 3409 engine hours, 1794 cutter head hours, good condition, ready to work !!!

Only wrapped 1400 bales, one owner

Very little use, under 500 bales

60" Hydraulic Driven Rotary Cutter. Skid Steer Quick Attach.

Double rotor rake, 24' working width rake, good condition

30' power merger

Replace your old roller bar rake for a fluffy windrow. Nice rake for any small hay operation., 540 PTO 12 Feet Width Hydraulic Lift Hay Curtain Runs off 540rpm PTO. Like new 12 ft rotary rake.

778 Rotary Harvesting Unit, Wide Crop Frame, Mechanical Pivoting Frame, Liquid Cooled Clutches Folding

Very nice low houred machine. Will make someone a great machine! Take advantage of CLAAS finance huge rebates and let this machine start putting quality feed in your bunk this year., Value: 989, Kernel Processor: Yes, Tier 2 ~ 775 h.p. MAN Engine Dynamic...

Twine only, nice clean dry hay baler

Rake Double Rotor Pull type, 24' working width

4 rotor, hydraulic fold tedder, good condition

Kuhn MM300 Merger. Perfect for new seedlings to pick up the hay and leave to dirt and rocks in the field. Very nice unit to take care of your hay crop. Runs off 540 PTO pump and hydraulic tilt.

Heads are available

778 Rotary Harvesting Unit, Two Speed, Oil Cooled Clutches Folding

Kernel Processor: Yes • PRWD • Without front end dive shaft • Nonadjustable wide rear axle 4-WD • Ether start kit • Hard faced knife bracket holders • Power chute with electric Kernal Processor lift • Engine block heater 110 volt • High arch spout...

Off of a FHX300 also fits FP240

2022 hrs on engine 1, 1494 hrs on engine 2. Lots of power and capacity! Clean machine that is ready to be put to work., Value: 1130, Kernel Processor: Yes, CLAAS 980 4WD Extra Long Spout Tier 2 ~ Twin Engine 884 h.p. CLAAS Kernel Processor Xenon Lights...

Well taken care of unit that will make someone a quality machine. 4WD and KP included., Value: 3700, Kernel Processor: Yes, Older unit that doesn't need DEF or a computer to be worked on.

16320 BALES, ROTO CUT, Net and Twine