Used Equipment Dozers For Sale In North East

REBUILT (by dealer) CAT eng; Berco U/C; 24" Pads; 14' Blade; Electric start; PS trans; Seat needs recovering; FOB - NC

CRANKS ON GAS & SWITCHES OVER TO DIESEL, GAS PART NEEDS REPAIRING - DIESEL RUNS GOOD

Ripper, Orops, 70 % Bottom, Sweeps, Consignment machine belongs to a contractor in NC,

Enclosed Cab, Heat, A/C LGP Dozer. PAT Blade, Trimble Ready, Extended Life U/C, Drawbar,3RD Spool Valve and Control, Rear screen and sweeps, turbine pre-cleaner. Excellent Condition.

(Rebuilt by dealer 3,598 hr); REMAN Trans (500hr); With JOHNNY COLLINS ROOT RAKE- Like New; Rails, Sprockets, Bottom Rollers 90%, Top Rollers & Track Pads 40%: Straight Blade w/ Tilt 10'6"; Sweeps & Back Cage; Good Seat; Draw bar; Very Good Condition;...

A Dozer + Ripper. County of Vulcan.

Comes with blade, ripper, A/C & Heat, NEW UC CAT.

A Blade, H110 winch

Parts machine; 16000 Engine & final drives good; Complete HD21 ripper; FOB-NC Pads 70%; Few good rollers; Idlers good; Sprockets 50%; Rails a little thin but useable; No radiator or blade; transmission bad

VPAT, Paccar Winch, NEW CAT UC at 5008 hrs.

Comes with blade, ripper, A/C & Heat.

Comes with blade, ripper.

A dozer, Allied winch

A Dozer, Ripper, Canopy.

ANGLE BLADE, TILTS, RIPPER

VPAT blade, erops, ripper, heat, A/C, NEW UNDERCARRIAGE Oct 01/14.

EROPS, Heat, AC, PAT Blade, ARO, Ripper Hyd, New UC @ 3,800 hours

AC, Heat, Joystick, PAT Blade, ARO, Tier 4i, 26" Sys One UC, Drawbar,

KOMATSU D39PX-23 CRAWLER DOZER WITH KOMATSU SAA4D95LE-6 DIRECT INJECTED, TURBOCHARGED, AFTERCOOLED TIER 4, 105HP DIESEL ENGINE, EQUIPPED WITH THE FOLLOWING: - WATER SEPARATOR - HYD DRIVEN REVERSIBLE COOLING FAN - 60 AMP ALTERNATOR - PCCSWITH ELECTRONIC...

VERY NICE! 80% undercarriage. REAR RIPPER! ANGLE BLADE with tilt! Cab with cold A/C.

Crawler Dozer, EROPS, A/C, 6-Way Blade, Ripper, Plumbed for Topcon 3D GPS System, NC

EXTREMELY NICE!!! REAR RIPPER!! Only 250 hours on NEW KOMATSU UNDERCARRIAGE!!! Cab with A/C. Good condition and appearance. Blade face will be plated. Has been used to push 627E scrapers.

EROPS, AC, Heat, 6VPAT blade, 33" Pads, ARO, Ripper Hyd, New U/C @4800 Hours

7100 Frame Hours, Less than 200Hrs on rebuilt engine, Chains and Pads Good, Sprockets and Idlers 50% +/-

Has 3DMC 2 Topcon system already on it for $45,000 extra will sell it without , EROPS, HEAT,AIR, Radio, Work lights, air susp. Seat,block heater,very clean This machine comes with total machine control Topcon already installed monitor, receiver complete...