Used Equipment Allis Chalmers For Sale In North Salt Lake

Wide front, no power steering, 13.6x28 rears, 6.00-16 fronts, power adjust rims good, fenders good, 12 volt, hood & grill ok, hand clutch good, repainted, new battery, runs good

Factory flat back, factory cab, aftermarket 3pt, 20.8x34 rears, 10.00-16 fronts, 540 pto, 2 remotes, runs good, sheetmetal straight, paint good, seat good, missing LH door & rear window, side toolbox, 2 front weights,

Allis Chalmers 12' pull type field cultivator, Kind: Rigid

*** Price Reduced!*** 26 PTO HP, 3.3L AC 4 Cyl Gas, 4/1 Non-Synchro, 18.4R26 Rear Tires, 3pt., 540 PTO, Wide Front

Allis-Chalmers CA

Parts machine; 16000 Engine & final drives good; Complete HD21 ripper; FOB-NC Pads 70%; Few good rollers; Idlers good; Sprockets 50%; Rails a little thin but useable; No radiator or blade; transmission bad

12R30 fully mounted, #78 air champ row units, 2 frt gauge wheels, bifold markers, DP springs, corn & bean plates, ACP3 monitor, shedded, hoppers good, shedded

Running When Parked 2 yr ago., Has Owned for a number of Years, Bowl in Good Condition, FOB-NC Engine A/C 19,000 Mark II, Front Tires Look Good 50%, Right Rear in Weeds Couldn't See, But Holding Air, Left Rear Went Flat After it was Parked, As Far as...

Tri-cycle, been sitting have not tried to start, gas

Factory flat back!!! 3484 hours, 20.8x34 rears, 10.00-16 fronts, factory cab, 540 pto, 2 remotes, aftermarket 3pt which can come off, runs good, sheetmetal straight, 2 front weights, toolbox, seat good, LH door & rear window missing, paint good

Selling "As Is", engine was disassembled by previous owner is complete but in many pieces, sheetmetal complete, 20.8x38 rears, 11.00x16 fronts, factory 3pt, no toplink, drawbar inc, used rebuilt 3500 AC engine is available for $2950 Additional Information

8397 hours, 20 speed power director trans, 18.4x38 rears, 11.00-16 fronts, 2 remotes, 540/1000 pto, power adj wheels, sheetmetal straight, runs good, recent inj pump & injectors, R134 AC, interior & seat good,

Diesel with all hyd New Idea 504 loader, shows 4845 hours, full vision cab with factory fenders, 18.4x28 rears, 16" fronts, power adjust wheels, 2 remotes, 3pt, 540 pto, 80" dirt bucket, brackets to rear axle, hoses to rear outlets, loader is straight,...

250hours on eng OH, 4 tooth grapple not mounted, missing rear window Selling "As IS" unknown hyd problems, dual 3100 loader, factory cab, shows 4899 hours, 18.4x38 rears, 10.00-16 fronts, 540/1000 pto, 2 remotes, 3pt, power adjust wheels, 8ft bucket,...

7272 hours, 20 speed Power Director trans, 18.4x38 rears, 11.00-16 fronts, 540/1000 pto, 2 remotes, 3pt with top link, power adjust wheels, straight, runs good, just ran through shop, cab interior rough, seat good

Gas engine, 16.9x34 rears, 6.50-16 fronts, wide front, factory 3pt, no toplink, 2 hyds, 540 pto, fenders good, power adjust rims good, sheetmetal straight, runs good Additional Information Additional Information Additional Information

Additional Information

*** Price Reduced!*** 26 PTO HP, 3.3L AC 4 Cyl Gas, 4/1 Non-Synchro, 18.4R26 Rear Tires, 3pt., 540 PTO, Wide Front

No rear remotes. Sheet Metal Straight.

Duals and front weights

Loader, Loader Make: Allis Chalmers, Loader Model: N/a

ALLIS CHALMERS 5050 UTILITY TRACTOR Configuration: Standard Navigation: No TireSize: Mid PTO: 540 Additional Information