New Equipment Row Crop For Sale In Chippewa Falls

8 Row, 30", Fits TR Series, Lateral Tilt, Factory Poly, Hydraulic Stripper Plates, Rate-9

New Holland 974 8 row 30" corn head

NH 974 8 row 30" corn head.

NH 976 6 row 30" corn head

8 Row, 30" Chopping, Fits CR Combine, Lateral Tilt, Factory Poly, Hydraulic Adjustable Stripper Plates, Outside Rollers Kit, Stalk Stompers, Rate-10

6R-30", Auger is a bit rough.

8 Row, 30", Fits CR Series, Lateral Tilt, Factory Poly, Hydraulic Stripper Plates, Rate-10

VERY CLEAN--knife roll---hydralic deck plates--, Poly Snouts, Header Height Sensor, Lateral Tilt, Used on New Holland 8090 Combine

NEW, NORTHSTAR 6R30, FITS CIH COMBINES, YOU SET UP AND SAVE, NO TRADES

Deck Plates, Headsight Insight PIN PNL020682 One owner- very clean-- Hyd.

8 Row, 30", Hugger, Mechanical Stripper Plates, Fits R62, Knves have been replaced, Nice straight header, Rate-7

6 Row, 30", Non Hugger, Rate-8

8 Row Wide Corn Head - Came off of a Late 8780 Combine - Setup for lateral tilt

8 Row, 30", Chopping, Fits JD 9770, Factory Poly, Electric Stripper Plates, Headsight 2 Sensor HHC,

6 Row, 30", Fits R62, Hugger, Rate-10

12 Row, 22", Chopping, Lateral Tilt, Factory Poly, Hydraulic Stripper Plates, May Wes Stalk Stompers, New knives and chains before 2015 season! Super clean and ready to go to the field! NH CR Mount, other mounts available Note: does not include corn reel...

4 ROW 30INCH, GOOD ROLLS, TIN IS STRAIGHT

8 Row, 30", Chopping, Factory Poly, Electric Stripper Plates, Super Clean, Rate-10 Gleaner mount R series

Capello Demonstration Unit - Less than 100 acres

2005 AGCO Gleaner 3000-830 Header Combine

Capello Demonstration Unit - Less than 500 acres

Number of Rows: 12 • Header Row Spacing: 30 • StalkMaster: Yes • intermeshing rolls, Stalkmaster: Yes,

Number of Rows: 12 • Header Row Spacing: 30 • StalkMaster: Yes Chopping Capabillity: Chopping

Number of Rows: 12 • Header Row Spacing: 30 • StalkMaster: Yes • Intermeshing rolls, row sensors, Stalkmaster: Yes,

Really Nice Used 8 Row Cornhead