Bauer Water Reel Engine Jon Deere 400 Hours Model #4045df150b Displacement 4.5 litre Power 60 kw @2500 rpm Murphy Switch Model OPLC-A-200 Pump Berkley Pump Model #B2-1/2-JQBM Impeller Dia 13.50 Reel Bauer Type 90-300 Trailer type T41 Controller Eco Star...
Has 1.0\" taper nozzle. SRNV100h nelson big gun with built in shut-off valve. Full or part circle with 1\" nozzle. SRNV100h nelson big gun with built-in shut-off valve. New, never been used.
All parts needed including three quick coupler valves. Irripod irrigation system. New, just needs to be put together. Consisting of 2 - 1 1/2\" x 300\' poly pipe, 1 - 1 1/2\" straight coupling, 1 - 1 1/2\" quick coupler key, 3 - 1 1/2\" quick coupler...
$87.00 per length. Includes the gasket and gates. 11 lengths left. New, has never been used. 8\" x 30\' with 30\" spacing gated pipe. New, includes gates and gaskets. 8\" x 30\' with 30 inch spacing.
Insectigator set up for pivot system single phase unit. Has a 10 gallon tank with mixer. Has mister mist'r injector. 1.9 gph 125 psi single phase unit with 10 gallon tank. New, never used.
The gates are on 20\" spacing and there is approx. Also 8\" berkley pto driven pump. All pipe is 10\". 990' of transmission pipe. Irrigation pipe. Some pipe is aluminum and some is plastic.
I can add a 40 horse pump and a big boss travelling gun All hook and latch. 40 joints of forty footers and 10 joints of fifty footers, all hook and latch in very good condition. I can add a 40 horse high pressure, high volume pump and a big boss travelling...
5.33\\" impeller 3\\" flanged suction x 2 1/2 x 7\\" discharge. 15 horsepower 3 phase 208-230/460 volt 3450 rpm. 280 gallons per minute at 120' head (52 psi) new, never used. Paco centrifugal pump 280 gpm at 120' head 15 hp 3 phase new, never used $1,125.00
Tuned up and ready to go. Located in Billings, MT Took in on trade when customer bought electric driven pumps when 3 phase line run in. Priced at $5,000.00 USD. Irrigation pump with diesel engine on a trailer with 500 gallon fuel tank.
Made by travis pattern and foundry. 8" pip epoxy coated irrigation risers. Spigot by gasketed, never used. 5 steel epoxy coated irrigation risers for 8\" pip pipe. New, never used.
5.33" impeller 3" flanged suction x 2 1/2 x 7" discharge. 15 horsepower 3 phase 208-230/460 volt 3450 rpm. 280 gallons per minute at 120' head (52 psi) new, never used. Paco 15 hp pump 3 phase 280 gallons per minute at 120 head (52 psi) model # 10-2507-0300021
Includes case h-01939, bracket l-03497, case gasket s-13760, impeller l-06131 (l5892 old #) packin s-13435 and lantern ring s-19200. Complete pump end not including shaft sleeve and packing follower.
280 GPM at 52 PSI. 5.33\\" impeller 3\\" flanged suction x 2 1/2 x 7\\" discharge. 280 gallons per minute at 120' head (52 psi) new, never used. 15 horsepower 3 phase 208-230/460 volt 3450 rpm.
Located in Billings, Montana. 1,000 gallon per minute at 150 foot head pressure. Unit taken of center pivot which was converted to three phase power. Pump gone through and new packing installed.
490 gpm at 60' head (26 psi), 350 gpm at 80' head (34 psi) and 240 gpm at 100' head (43 psi). Submersible cast iron turbine pump with bronze impellers. 400 gallon per minute rating.
Uses packing on shaft. 100 gpm at 143 lbs pressure at 3600 rpm. Berkeley b 1 1/2zrl frame mount pump new, never used. Frame mount centrifugal pump berkeley b 1 1/2zrl b52383 clockwise rotation new, never used
8" suction head # 7296, inpeller # 7297, volute # 298B, gear box housing # 6412 and bottom base # 6409. 68A-G Gorman Rupp used parts. $300.00 for all. 68A-G PTO pump used parts. Parts are in pretty good condition but there are no gears with it.
Wheel gear drive for valley pivots. Valley 52:1 gear drives with extended shaft, have never been installed on a pivot. New, never used. 52:1 worm gear ratio with extended shaft. $290.00 each, have 6 on hand.
Located in Billings, Montana. 1,000 gallons per minute at 65 punds pressure. Irrigation pump assembly on trailer with 500 gallon fuel tank. Pump and engine serviced ready to go. Pump taken off pivot when 3 phase power became available.
It has 788 current hours on the machine. $35,000 OBO This machine currently is located in my Billings, MT location. It is an open canopy machine with rubber tracks. It includes a bucket.
3\" krohne 4020/k/d/hart/6 flow meter. Unit was ordered in for a system customer defaulted on. Unit has 3\" flanged ends. 3\" flow meter new - never used 0 - 500 gpm ifm 4020 k/d/hart/6 s07 23644 iso kl.h q: 0 - 500 usgal/min gk 2.4228 i: 4 - 20 ma r1,=0.5kohm...
2006 621D Case Loader. Interior excellent condition. 21,000lbs dry weight. 1999 hours with Cummins Diesel Motor. 70% rubber with ride control. Going out of business so no longer needing it.
Old iron such as dump rakes, steel wheels, old wooden wagon, hay sickle, milk cans and other items, all on an old Ranch in Montana. Old iron such as dump rakes, steel wheels, old wooden wagon, hay sickle, all on an old Ranch in Montana.
Baby Blue in color, this antique is available today. Great for collectors!!! 1964 GMC 1&1/2 ton Stock truck. This truck has had two owners and has been used most recently for a dude ranch application hauling horses to trail heads.