Livestock Waterers Farm Supplies For Sale In San Diego

This white pin holds the upper arm to the top base.

Includes screen, retainer ring, diaphragm, shut-off pad and float. Repair Kit for 716H Valve.

Guaranteed for 1 year & SAFE IN PLASTIC. Constructed of Cast Aluminum for ultimate effiency & safety. Thermostatically controlled to only run when necessary. Good for us in containers up to 50 gallons and sold with many different manufactured automatic...

Its diaphragm principle of operation allows the Megaflow to give flows of up to 90 gallons per minute. Features High flow Compact robust construction 3/4″-2 1/2″ water level differential (increases as water pressure increases) Positive on/off operation...

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

A drain plug for Arkfeld waterers - 2" in size - Cork.

20 Gallon, 36" x 35" x 25" - 1060# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

Red octagon plunger that fits inside the Mira Fount cattle waterer RED valve.

A drain plug for the Arkfeld waterers - 2" in size - Black rubber.

SPI 90 degree elbow for all models.

Use this valve assembly with the J303 with without heat.

Connects valve to 301 round float. A brass rod float arm 1/4" x 1 1/4" with threads on each end.

Robert's Brass 1/2" orfice Valve complete with sand plunger and arms.

Tank features pull plug and vent for easy filling. The unique design includes a 25-gallon water capacity (FDA approved) combined with a large storage compartment and durable lid construction for use as a step.

Apex replacement float with string included.

The R400 series is a high-capacity float valve with male NPT inlet and outlet connections. Robert's Brass 3/8" orifice Valve complete with plunger and arms. This model features an adjustable short arm for customizing water level.

These valves are easy to set up and install and their function is so simplistic it is hard for them to fail. Arrived within three days. I was purchasing to replace an older one that finally wore out.

THE RACE IS OVER. Drinker is very easy to clean-no disassembly for cleaning required. OUR PERFORMANCE ONE BOX STALL DRINKER WINS BY SEVERAL LENGTHS - For corner installations in box stalls--but can be installed outdoors as well.

Saves money by using power only when temperatures require. Works automatically to ambient temperature. Turns on at 35 degrees & turns off at 45 degrees. Operates with any 15 amp 120V electric heater or fan.

Measures 37” x 27 1/2” x 13”, ash grey color. 35-Gallon Water Tank, small enough you can tip over to drain (does not have drain plug). 5-year warranty.

The Tru-Test Apex Xtraflo 3/4" valve with brass rod arm attached to the black round float for Anti-Siphon use.

Connects valve to 301 round float. A brass rod float arm 1/4" x 8" with threads on each end.

This Front Float Valve fits Models 101, 202 & 404 with or without heat.

Eliminates algae problems as water is not exposed to sunlight. Whenever an animal drinks, it removes a quantity of water which is immediately replaced by ground water through the valve.

This part number is for the arm only & is usually used on the Polar Max waterers. Pride of the Farm Plastic 3 5/8" Float arm is connected to the Power Link by a thumbscrew & then screws directly into the Poly float.

SPI 351/352 New Generation Gasket.