Livestock Waterers Farm Supplies For Sale In Idaho

Screw that holds the float connect to the top of the float.

XtraFlo compact diaphragm valve has full-flow, high volume fill. The valve has a 1” water level differential between opening and closing, reducing pump motor overload. Working pressure range is 4-175 psi, working water temperature range 34-140°F.

Trough-O-Matic Float Valve Repair Kit

These are not included when ordering a base only. There are four base screws that hold the top base to the bottom base.

No inside working parts included. The orange male fitting end of the Franklin Valve.

Unique covered design aids in eliminating debris from contaminating the water supply Holds 2 gallons Bottom drain for easy cleaning Can be attached to timber rails, wall, pipe rails or steel gate Includes 4 self taping screws & 4 cable ties for installation...

Float Arm for the Mira Fount M3360, M3410, M3410-4, M3465 waterer.

Valve works with up to 70 lbs. Water pressure and has a capacity of 375 gallons per hour. The Trough-O-Matic float valve features a longer, deeper float which gives more leverage. The rust-proof plastic case comes with an adapter to fit a 3/4" male or...

Robert's 3/4" rubber plunger seat only.

Blue octagon plunger that fits inside the Mira Fount cattle waterer valve.

Turns on at 36 degrees and turns off at 48 degrees. Often used in Franklin & Arkfeld waterers. Surface mount thermostat used in galvanized waterers.

SPI 351 (old style) gasket only.

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

1000 watt x 120 volt heating element only. Arkfeld waterer element replacement.

If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill the hole. All edges have been rounded for safety & strength.

Typical heating cost for one heating season only $10! 250 Watt, 110 volt heater.

The Megaflow is compact, robust and manufactured from non-corroding materials. Features High flow Compact robust construction 3/4″-2 1/2″ water level differential (increases as water pressure increases) Positive on/off operation Lock off with cord...

This repair kit fits the Models 101, 202 & 404 with or without heat.

Stainless steel access plates. THE RACE IS OVER. Half moon design on back corner for securing up to a 2 inch (5.1 cm) PVC tube for plumbing from above or below. Model VT100 valve delivers about 2 1/2 gallons (9.5 liters) per minute.

This high volume, full flowing valve is protected by its own multi-functional bell shaped body of reinforced nylon resin. It not only ends flooding, breakdown and water loss, it also does away with breakage of floats, balls, and lever arms by livestock.

It has O'ring on one side & a Diaphragm on the other (not included). #7 on breakdown. Pride of the Farm 5/32" Orifice on a VP124 Valve.

3/4" male to female hose used to hook up the water line to the waterer.

No other parts are included with this Power Link. #1 on breakdown. Pride of the Farm Power Link locks to the VP124 valve body with a link pin & then thumbscrews to the float arm.

Connects valve to 301 round float. A brass rod float arm 1/4" x 7" with threads on each end.

Easy for you and your animals. They don�t have to learn to lift flaps or push balls and floats are out of the way; they just use their natural sucking method to drink from the open hole.

600 watt x 120 volt heating element with surface mount thermostat included. Arkfeld waterer element & thermostat replacement.

This round barrel-shaped tank holds 35 gallons of water. A great new way to haul additional water for your animals in your trailer or in the back of the pickup.