✓ Premier panels fit and chain between brackets inside of headgate stand frame
✓ For maximum stability we recommend driving T-posts outside the rear corners of the headgate stand and chain securely
✓ Weight: Approximately: 103 pounds
✓ Shipping Dimensions: Approximately 78 x 20 x 12 inches. (oversized)
✓ Recommended for driving T-Posts and using the attached chains at the rear outside of each corner to secure headgate and stand from moving forward as cattle work through the alley
Hinge mounting hardware included. Hole provided for securing with a chain. High quality plastic construction, measures 46” x 40” with center height at 29 1/2” to fit a 48” opening.
Convenient to use when more than one wire is required to hold stock. Ideal for use in temporary electric fencing with round posts from 1/4" to 5/8" diameter.
Activated when fence pulse is detected Switch to change between DVM and Current Meter modes Retractable voltage probe for reading voltage on energizers and other hard to reach areas Micro-chip technology that enables low voltage operation Detachable ground...
The latch installed very easy. (the only drawback was it did not come with the second bolt or any of the nuts to attach it to the gate. This latch allows you to open the gate from either direction.
✓ Opens easily with one had
✓ Accepts padlock (not included)
✓ Used with round tube gates 1-5/8 In - 2 In O.D.
✓ Helps to prevent gate end sagging and swinging
✓ Shipping Dimensions: Approximately 11.75 x 4.34 x 2.72 inches.
The 8" tall sturdy metal hub wheel comes with shims for use on gates with less than 1 7/8" O.D. pipe. Works like riding on air! The clamp is a pre-formed piece for a 2" round pipe.
Fits standard pipe fence from 1-5/8" to 1-7/8". Connect your horizontal pipe fence rail to a vertical post or pipe anywhere in your fence line, creating an instant 90 degree angle in your corral or pen.
One 49' roll is adequate for connection of two standard gates. Highly conductive 12-gauge aluminum wire insulated with heavy polyethylene coating for up to 20,000 volts. Ideal for all underground applications.
This sensitizes the spark gap with your entire fence, and if something touches the fence, the Knocker spark gap will disengage and the full shock of the charger will go to whatever is touching your fence.
