Stretcher consists of two sides that detach and face each other on either side of fence. Chain is attached to stretcher and used in conjunction with come along to pull fence tight to eliminate fence bulge.
Ideal for electric fence repair or construction. For smooth and barbed wire. Cuts installation time in half. All TwistEnds are conductive. Solution for terminating wire fencing to T-Post and post fencing systems.
Forged fence tool is heavy duty, with vinyl grip. Suitable for many jobs, including stretching and twisting wires, as a hammer, nail puller, spade, and as a wire cutting plier.
Prevents gate from sagging. One-handed operation, designed so it can be opened from horseback. Powder coated for long life; includes hardware to mount on gate. 5” x 3 1/4” x 1 3/8”.
No back-breaking wiggling or pulling. Removes steel T-Post without the aid of chains, jacks or motorized assistance. Use in remote areas. The simple design is built to last.
Starting and pulling point on one jaw with corrugated hammer head on the other. For wood and steel posts. Front pulls staples, lifts tugs, and splices wire. Wire stretcher located behind the joint.
Due to manufacturer shipping constraints, the item(s) below must reach a total value of $5000.00 (mix and match on all Powder Creek products) in order to be purchased. Features a chain latch and pin and clip connectors to allow it to easily pin up to...
Ideal for use in temporary electric fencing with round posts from 1/4" to 5/8" diameter. Convenient to use when more than one wire is required to hold stock.
Due to the line current, this light is ideal for fencers under 3 joules. The Electric Fence Lights only draw current from your fence until the moment something touches the fence. So don't worry if your tester is showing a draw down on your fence while...
Multi-mode fault finding tool: Current Meter and Digital Volt Meter (DVM) Convenient pocket size Water-resistant and impact-resistant case Large easy-to-read LCD display Long life battery - up to 3 years Auto ON/OFF.
Features 2 double-post rope clamps and joined by 32” of 12 gauge, shielded wire. Connect and transfer power from 1 strand of 1/4” electric rope or braid to another. May be used to terminate the rope at the end of the fence.
Intertwine legs of bracket into existing mesh, woven, or barbed wire. Stand off bracket keeps electric fence approximately 7" away from the existing fence. Pin Lock holds the wire firmly in place.