Farm Equipment Livestock Waterers For Sale In Durham

High Country Plastics water tanks are rotational molded with high quality FDA approved UV protected plastic to ensure uniform thickness & strength for maximum durability and longevity.

Custom made to use in all Rubbermaid stock tanks with 1500 Watts of power. Unit is unnoticed by livestock - no cord in water. Easy to install & installs in only minutes. Guaranteed for 1 year & SAFE IN PLASTIC.

Robert's Brass cotter key that connects the long arm to the valve body.

No more-no less. The MicroSweeper is plumbed near the float valve, usually in the port where the petcock was installed. In operation, the MicroSweeper turns on at 41 degrees (F) and turns off at 42 degrees (F).

Nature's ground water temperature does this job. Sealed bottom keeps out moisture & rodents. No heat well needed; use an 8-12" tile; can be fitted on most existing pads. Livestock can drink out of both flaps at the same time, not always so with a ball...

Robert's 1/2" rubber plunger seat only.

White styrofoam triangular disc float only.

Pride of the Farm White Poly Float that screws into the float arm & turns the water off & on in your waterers. It measures 3.25" x 4.25" x 2.38".

This Complete Valve is used on the J303 or J303EF Corner Mount Horse Stall Waterer.

Adjustable, submersible thermostat that can be turned as low as 10 degree turn on up to 80 degree turn off.

40 Watt x 36" Heat Tape used in the Energy Efficient & All Purpose waterers.

Robert's 3/4" rubber plunger seat only.

Our 8 notches do not protrude where they can be hit. It is loaded with features not available on any competing trough drinker. Warmer water pushes through the ports and cooler water returns under the baffle.

Blue plastic valve assembly fits a 3/4" FPT with a 3/4" orfice inlet. Mostly used on cattle waterers.

6, 7 and 12 (see parts list in pictures attached) B81 Hook, Rod, Cone and Nut Assembly for WFD85 and MFD85 field drinker. B81 includes: Ref.

High Country Plastics water tanks are rotational molded with high quality FDA approved UV protected plastic to ensure uniform thickness & strength for maximum durability & longevity.

Jug Thermostat fits Models 101, 202, 303 & 404 with heat.

SPI 351/352 New Generation Gasket.

Pride of the Farm Plastic Thumb Screw that connects the Power Link & the Float arm (not included). #11 on breakdown.

SPI foamed 4x4 energy free waterer door only.

There are four base screws that hold the top base to the bottom base. These are not included when ordering a base only.

Rojo Float Valves are ideal for filling water drinking troughs for small numbers of animals. FEATURES: Side, Bottom, Top Mounting Valve body screws apart by hand for easy servicing Flow stops when unscrewed for servicing Supplied with back-nut and seal...

This diaphragm fits all Jug Model Valves.

Thermostat ONLY for all Johnson Concrete Waterer Models.

Stock Tank With Built-In Drinker Model PRE224BID comes standard with one built-in drinker. -Minimal Assembly -Strong Utra-violet Light Protection to prevent Fading/Cracking -One Inch (2.54 cm) Drain Plug (Drain is to the left as you face drinker) -Drinker...

80 Watt Immersible element used in the PC 1 waterer.