Farm Equipment Livestock Waterers For Sale In Bridgeport

It moves the upper to and is also held by a thumbscrew to the float arm. The lower arm is orange and is located in the bottom bracket of the top base and is held by a lock pin.

Blue octagon plunger that fits inside the Mira Fount cattle waterer valve.

Connects valve to 301 round float. A brass rod float arm 1/4" x 2" with threads on each end.

Valve 36" Float Cord Only.

Must be used with part #400267 Plunger Only. This black seat fits inside the plunger and shuts off the water through the orfice.

21.75" W x 28" L x 16" H This two hole, 5.2 gallon waterers uses a 250 or 500 watt submersible heater and can easily ship UPS. The VS20LPC has an insulated valve cavity and one piece hatch for no air loss.

The heat tube is designed to mate with the cavity under the drinker base. The ground mount tube ONLY provides some cold weather protection to your barn stall waterer (not included), but you may need to add heat tape to the water supply line.

Suggested where sugar sand is a problem in the water supply. Robert's Brass 3/4" sand plunger only for replacement in existing 3/4" valve.

68 Gallon, 72" x 35" x 25" - 1910# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

Hollow black plug used in all Franklin galvanized waterers.

A drain plug for Arkfeld waterers - 2" in size - Cork.

Connects valve to 301 round float. A brass rod float arm 1/4" x 10" with threads on each end.

It is held by a float screw and connects on to the bottom of the float arm. Plastic piece that sits on top of the float.

Available in Aqua Blue color only. If the tank gets a small leak due to unforeseen circumstances, such as a bullet hole, it can be braze welded with a common butane torch to fill in the hole.

Connects valve to 301 round float. A brass rod float arm 1/4" x 1 1/4" with threads on each end.

Blue 10" replacement ball for the Mira Fount M3465 & M3465E cattle waterer.

Connects valve to 301 round float A brass rod float arm 1/4" x 1 1/2" with threads on each end.

Meets "Grade A" Dairy requirements (non-siphoning). Engineered with the farmer in mind, this waterer allows easy access to submersible heater, water line, incoming services and provides effortless cleaning; an extremely low maintenance product! This waterer...

68 Gallon, 72" x 35" x 25" - 1910# All J Models Heavy duty concrete tank (reinforced with rebar and fibermesh Safe, quick and easy to lift and set Epoxy painted trough and outside Chamfered edges Notched top for controlled overflow Brass or plastic water...

Johnson Waterer Element Clips to hold the heating element.

Robert's Brass 3/4" plunger only for replacement in existing 3/4" valve.

Same desription as the J202 EXCEPT THIS UNIT HAS NO HEAT!

Robert's shut off only arm attached to the bottom of the Robert's Brass Valve.

Float Arm for the Mira Fount M3360, M3410, M3410-4, M3465 waterer.

Robert's 1/2" rubber cup ring that fits on the brass plunger.

The orange cap only that fits over the insides of the Franklin Valve.

SUPERB ENERGY EFFICIENCY FOR NEW INSTALLATIONS YOU ONLY NEED ONE UNIT FOR UP TO 150 HEAD Please see our brochure WP012 Brochure