Accessories Electric Fencing For Sale In California

Has a crank handle that operates like a ratchet for fence tension; will handle up to 1/2 mile of Bayguard. Designed so it can be hung from a permanent fence wire or bolted to a post.

Simply slide over the post and you're done. 10-year warranty. For corner or end posts. Fits up to 8" post. No wire tying, fast and simple. Strong, stainless steel cable for long life.

Aluminum connector with wire to connect polytape or polywire to your electric fence charger.

Use in vertical brace post corner and brace assemblies. Rust-resistant Zareba 10-Inch Galvanized Brace Pin is for use when building corner and brace assemblies for your fence line.

Replacement spool for winding and unwinding portable fencing.

Absorbs up to 34 watts of transient power. Helps protect your 110-volt plug in energizer from power surges caused by lightning strikes. Plugs into any 110 volt outlet, limits high voltage spikes to 350 volts.

One 49' roll is adequate for connection of two standard gates. Highly conductive 12-gauge aluminum wire insulated with heavy polyethylene coating for up to 20,000 volts. Ideal for all underground applications.

Install the S10 or S16 Energizer on a Gallagher Ring Top Post (#40990) using this post mount. Easy to use and portable!

Ground rod clamp connects grounding wire to the ground rod.

For use with low impedance fence chargers. Easy-to-read digital design, reads up to 19.9 kilovolts. Matches the performance meter on Parmak fence chargers but will also read all fence chargers accurately.

Bolt measures 6” (measured from the 90 degree angle to the point of bolt.) Used with Hot Rope or polywire to turn corners or as an end insulator.

Spring loaded PVC gate handle.

Just replace your fuse and you're good to go. The only external fuse protection for fence chargers in the world. Lightning blows up the fuse and not your fencer.

Has an in-line length adjustor for gates from 8 ft. Comes complete with two 2-way gate anchors. Electri-Gate is a high conductive stretchable cord with a high impact plastic handle.

Easy to repair. All-in-one multi-strand electrification gate. Highly flexible gate width, perfect for whatever space you need. Should a strand break, simply change out the tape. Quick and easy to install from one wood post to another.

Gallagher Cut-Off Switch (Knife) is used at gates and for easy location of fault finding. Switch off a section of fence for maintenance and routine checks.

When a Storm Guard Module is in use, it can absorb this surge and fail, instead of causing failure to your fence charger. Suitable for use with any model or brand of low impedance fence charger that has 1 joule or greater output.

Made from 1/4” spring steel. Fence compression spring is used to determine wire tension on your fence line. Helps absorb expansion and contraction of the fence wire. Spring is 1 1/2” diameter, expands from 9” to 18”.

Claw style insulator ideal for use in temporary electric fencing with rod posts 3/16" - 3/8" diameter. Fits Ring Top Post (#40990).

Stainless steel clips for use with 3/8" or 1/2" fiberglass posts. Pig tail clips may be used instead of insulators.

Protect your valuable horses and livestock from serious injury and unsightly scrapes. Safe-T post caps are designed to conform to a wide range of steel post sizes and stay on tight, eliminating the hazards of sharp, jagged post tops.